Organise your Road or MTB in your Van/ car or truck with a 300mm Screw-Down Rail – 1xT-Slot.
Fitting a rail gives you next level organising. Multiple fork mounts can be added and re positioned at the twist of a knob. (Number of fork mounts that will fit depends on the length of rail)
Add a 300mm Screw-Down Rail – 1xT-Slot to your vehicle floor then add one of our rail fitting fork mounts. You can now adjust the position of your fork mount or remove when not in use.
The 300mm Screw-Down Rail – 1xT-Slot is 40mm wide x 16mm high x 600mm long. Each rail has a single t-nut slot and 2 x end caps. We have also predrilled with 4 countersunk fixing holes so you don’t have to. Once fitted to your vehicle the t-nuts (supplied with the rail fitting Fork Mounts) just slip in from above so you don’t need to worry about bashing the end caps off.
Your Fork Mount/ Mounts can then be dropped on, finger knobs located in the t-nuts and positioned/ re positioned before tightening. When you need the floor space for something else undo the finger knobs and remove the Fork Mounts leaving the Rail ready for the next ride.
If fitting multiple bikes you might be interested in adding an off-set mounting plate to your 300mm Screw-Down Rail – 1xT-Slot. This allows your fork mount to be adjusted allowing bikes to be nested closer together.
*Don’t worry if you have already purchased one of our surface mount Fork Mounts we’ve got you covered, just buy the separate Fork mount rail fixing kit when adding the rail to your basket
What you get:
- 1 x Single T-Slot, 40mm W x 16mm H x 300mm L Extrusion Rail (Pre Drilled 4 x Csk Holes)
- 2 x End Caps